Slot Configuration For Emg80; Emg80 Slot Configuration (Standard) - iPECS eMG80 Administration Manual

Hide thumbs Also See for eMG80:

Table of Contents

iPECS eMG80 & eMG800 & UCP

Administration and Programming Manual

2.2 Slot configuration for eMG80

The built-in interface ports, ports of the optional Interface boards and the optional Function

boards are organized into Slots. For the built-in and optional board interfaces two Slots are

defined, a Slot for the Stations and a Slot for the CO/IP Lines. The Function boards use a single

Slot to identify the board location. The Slots are used during the initialization routines, refer to

section 2.3, to identify the installed equipment and establish the numbering for the Stations,

CO/IP lines, and Function board channels. An additional Slot (Slot 18) is used by the software

to identify the Conferencing channels as a virtual board.

The figure below depicts the Slot locations and Table 2.2-1 lists the Slots, the hardware

designation for boards applicable for the Slot and the software reference for the type of

Table 2.2-1 eMG80 Slot Configuration (Standard)

H/W Reference

Built-in KSU Station interface group

KSUA and KSUI: 1-DKT & 7-Hybrid

KSUAD & KSUID: 8-DKT &-4 SLT

CH204 or BH104

CH408, BH208 or HYB8

CS416 or SLIB16

CH204 or BH104

CH408, BH208 or HYB8

CS416 or SLIB16

Built-in EKSU Station interface group

CH408 or HYB8

CS416 or SLIB16

S/W Reference