USB HUB4 MAAP:
1.
Place the HUB4 MAAP in the one-gang opening in the mounting frame.
2.
Insert the included hex screws through the HUB4 front panel mounting holes and the
holes in the MAAP mounting frame.
3.
Attach the provided hex nuts to the screws on the back of the frame.
Mounting the hub to a wall box
To mount the HUB4 to an electrical junction box in a wall or furniture,
1.
Mount the HUB4 into a mounting frame as described above under "Mounting the hub
to a mounting frame."
2.
Attach all power and USB cables to the HUB4 rear panel connectors and test the
system.
3.
Attach the mounting frame with the attached HUB4 to the wall box, using the two
included mounting screws (see figure 12).
NOTE: Use an AAP or MAAP blank for any unused faceplate openings.
Wall opening
flush with
edge of box
Extron
USB HUB4
USB Hub
Figure 12.
Installing a USB HUB4 MAAP in a One-gang Wall Box
Mounting the hub to a mounting bracket
1.
Mount the HUB4 to an AAP or MAAP mounting frame (see
mounting frame
on the previous page).
2.
Attach all required cables to the rear panel connectors of the HUB4 and test the
system.
3.
Attach the AAP or MAAP mounting frame with the attached HUB4 to the mounting
bracket using the two included mounting screws (see
NOTE: Use an AAP or MAAP blank for any unused faceplate openings.
W E
R
P O
A P
IT Y
TI V
M A
0 1
A C
T 0
V T
P
A A
4 M
U B
B H
U S
Extron
CPM101
Mounting Frame
Mounting the hub to a
figure 13
USB HUB4 Series • Installation
on the next page).
12