Product Notes; Tools Needed - Danfoss FCD300 Service Manual

6.

Product Notes

For software updates see product note no 6
For description of modifications of the control plug see product note no 7
For description of the modification on the earth spring see product note no 8
NB
Products notes can be found on Danfoss Drives intranet.
7.

Tools needed

• Torx screw driver TX20 for joining /splitting electronic part and installation part.
• Torx screw driver TX10 for internal screws for fixing control card cassette and
printed circuit boards.
• Torque wrench (0-5 Nm) with bits TX10 and TX20
• LCP2 Control unit (175N0131)
• LCP2 plug kit (175N2118)
• LCP2 cable (175N0162)
• Service tool kit (175N2404, new tool under construction) gives access to all
electrical terminals during operation.
• ESD protection kit - wristband and Portable Bench mat.
• True RMS Digital Multimeter
• True RMS Current Clamp
• Analog voltmeter
Release 01/2003
Revise 08/01/2003 by DD Service Manager, Steffen Sundbæk
Service Manual FCD 300
10