Replacing The Display Panel; Procedure; Post-Requisites - Dell Alienware 17 R4 Service Manual

Replacing the display panel

WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your
computer, follow the instructions in
For more safety best practices, see the Regulatory Compliance home
page at www.dell.com/regulatory_compliance.

Procedure

1 Slide the display cable into the connector on the display panel and close the
latch to secure the cable.
2 Adhere the tape that secures the display cable to the display panel.
3 Turn the display panel over and gently place it on the display back-cover and
antenna assembly.
4 Align the screw holes on the display panel with the screw holes on the display
back-cover and antenna assembly.
5 Replace the four screws (M2x3) that secure the display panel to the display
back-cover and antenna assembly.

Post-requisites

1 Replace the
2 Replace the
3 Replace the
4 Follow the procedure from step 2 to step 15 in
5 Replace the
6 Replace the
7 Replace the
8 Replace the
9 Replace the
10 Follow the procedure from step 4 to step 7 in
11 Replace the
logo board.
display bezel.
display assembly.
computer base.
rear-I/O cover.
memory modules.
solid-state drive.
wireless card.
base cover.
computer. After working inside your
After working inside your
"Replacing the hard
"Replacing the system
computer.
board".
drive".
107