SMA SUNNY SENSORBOX Installation Manual page 31

SMA America, LLC
Mounting the temperature sensor on the PV module
CAUTION
Risk of chemical burns from contact with the thermally conductive adhesive.
• Avoid any contact with the skin, mucous membranes and eyes.
• Wear appropriate protective clothing, gloves and goggles when working on the
sensor.
• Follow the safety precautions and instructions from the manufacturer of the thermally
conductive adhesive.
1. The mounting location must be determined based on the cable length of the sensor and the
applicable site requirements.
2. Prepare the thermally conductive adhesive included in the delivery according to the instructions
of the manufacturer. Observe the processing and hardening times specified by the
manufacturer.
3. Affix the module temperature sensor to the bottom of
a PV module using the thermally conductive
adhesive.
4. Using strips of adhesive tape, affix the module
temperature sensor and the cable to the bottom of the
PV module.
5. Once the thermally conductive adhesive is hardened, remove the adhesive tape strips.
☑ The module temperature sensor is now mounted.
Installation Manual
Mounting the device
Sensorbox-eng-IA-IUS-112515 31