Power Off; Selecting The Interface Type; Interface Selection; Configuring The Interface - Datalogic Gryphon GBT4400 Quick Reference Manual

Power Off

Scan the bar code below to shut off power to the BT handheld
until the next trigger pull.

Selecting the Interface Type

Upon completing the physical connection between the reader
and its host, proceed directly to Interface Selection below for
information and programming for the interface type the
reader is connected to (for example: RS-232, Keyboard Wedge,
USB, etc.) and scan the appropriate bar code to select your
system's correct interface type.

Interface Selection

Each reader version will support one of the following sets of
host interfaces:
General Purpose Versions —
board Wedge, Wand.
Retail Point of Sale Versions —
IBM 46XX.
Information and programming options for each interface type
are provided in this section. For defaults and additional infor-
mation associated with each interface, proceed to the corre-
sponding chapter in the Gryphon™ 4400 PRG.

Configuring the Interface

Scan the programming bar code which selects the appropriate
interface type for the system the reader will be connected to.
NOTE
Quick Reference Guide
Unlike some other programming features and
options, interface selections require that you scan
only one programming bar code label. DO NOT
scan an ENTER/EXIT bar code prior to scanning an
interface selection bar code.
Some interfaces require the scanner to start in the
disabled state when powered up. If additional
scanner configuration is desired while in this
state, pull the trigger and hold for 5 seconds. The
scanner will change to a state that allows pro-
gramming with bar codes.
PowerOff
RS-232, RS-232 OPOS, USB, Key-
RS-232, RS-232 OPOS, USB,
Power Off
21