Vuly Lift Pro Assembly Manual page 12

Mat and springs
4
STEP
A. Unravel and lay your trampoline Mat inside
the frame, ensuring that it is flat, with the print
facing upwards.
B. Find the Vuly Batch Tag on the Mat, and rotate
the Mat so that the Batch Tag lines up with a
Joiner Pole.
Note: The net entrance will be between the two Joiner Poles to the right of the Batch Tag.
Rotate your Mat to the desired position, but always ensure that the Batch Tag lines up
with a Joiner Pole. The Vuly logo should be centred between two Joiner Poles.
5
STEP
A. Attach a Spring into the D-shackle that is on the right of the Batch Tag,
and connect it to the Spring hole directly on the right of a Joiner Pole.
Note: You must hook the short ends of the Spring hooks into the
D-shackles on the Mat, and hook the long ends into the Frame.
B. Go to the opposite side of the frame – counting Springs against
D-shackles as you go – and connect a Spring to the right of the
opposite Joiner Pole to its corresponding D-shackle.
Tip: Hooking the Spring to the Mat and pulling back to the Frame
is the easiest connection method. Alternatively, use the Spring tool
to pull and connect the Springs from the Mat to the Frame.
C. Repeat for each Spring and D-shackle to the right of every Joiner
Pole. Then, repeat for each Spring to the left of each Joiner Pole.
C
12
B
A