Download  Print this page

Failsafe Of The System Which Uses The Inverter - Mitsubishi Electric FR-E720-0.1K Instruction Manual

Fr-e700 series.
Hide thumbs

Advertisement

Table of Contents

FAILSAFE OF THE SYSTEM WHICH USES THE INVERTER

4 FAILSAFE OF THE SYSTEM WHICH USES THE INVERTER
When a fault occurs, the inverter trips to output a fault signal. However, a fault output signal may not be output at an inverter
fault occurrence when the detection circuit or output circuit fails, etc. Although Mitsubishi Electric assures best quality
products, provide an interlock which uses inverter status output signals to prevent accidents such as damage to machine
when the inverter fails for some reason and at the same time consider the system configuration where failsafe from outside
the inverter, without using the inverter, is enabled even if the inverter fails.
(1) Interlock method which uses the inverter status output signals
By combining the inverter status output signals to provide an interlock as shown below, an inverter alarm can be
detected.
No. Interlock Method
Inverter protective
1)
function operation
Inverter running
2)
status
Inverter running
3)
status
Inverter running
4)
status
(2) Backup method outside the inverter
Even if the interlock is provided by the inverter status signal, enough failsafe is not ensured depending on the failure
status of the inverter itself. For example, when the inverter CPU fails, even if the interlock is provided using the inverter
fault output signal, start signal and RUN signal output, there is a case where a fault output signal is not output and RUN
signal is kept output even if an inverter fault occurs.
Provide a speed detector to detect the motor speed and current detector to detect the motor current and consider the
backup system such as checking up as below according to the level of importance of the system.
1) Start signal and actual operation check
Check the motor running and motor current while the start signal is input to the inverter by comparing the start signal to
the inverter and detected speed of the speed detector or detected current of the current detector. Note that the motor
current runs as the motor is running for the period until the motor stops since the inverter starts decelerating even if the
start signal turns off. For the logic check, configure a sequence considering the inverter deceleration time. In addition, it is
recommended to check the three-phase current when using the current detector.
2) Command speed and actual operation check
Check if there is no gap between the actual speed and commanded speed by comparing the inverter speed command
and detected speed of the speed detector.
System failure
23
Check Method
Operation check of an alarm contact
Circuit error detection by negative logic
Operation ready signal check
Logic check of the start signal and
running signal
Logic check of the start signal and
output current
Controller
Inverter
To the alarm detection sensor
Used Signals
Fault (ALM) signal
Operation ready (RY) signal
Start signal (STF signal, STR signal)
Inverter running (RUN) signal
Start signal (STF signal, STR signal)
Output current detection (Y12) signal
Sensor
(speed, temperature,
air volume, etc.)
Refer to Page
Refer to Chapter 4 of the
FR-E700 Instruction
Manual (Applied).
Refer to Chapter 4 of the
FR-E700 Instruction
Manual (Applied).
Refer to Chapter 4 of the
FR-E700 Instruction
Manual (Applied).
Refer to Chapter 4 of the
FR-E700 Instruction
Manual (Applied).

Advertisement

Table of Contents

   Also See for Mitsubishi Electric FR-E720-0.1K

   Related Manuals for Mitsubishi Electric FR-E720-0.1K

Comments to this Manuals

Symbols: 0
Latest comments: