Mitsubishi Electric FR-E720-0.1K Instruction Manual page 29

Fr-e700 series
Hide thumbs Also See for FR-E720-0.1K:
Table of Contents

Advertisement

Start/stop from the operation panel (PU operation)
5.1.2
Using the setting dial like a potentiometer to perform operation
POINT
 Set "0" (extended parameter valid) in Pr. 160 User group read selection.
 Set "1" (setting dial potentiometer mode) in Pr. 161 Frequency setting/key lock operation selection.
Operation example
Change the frequency from 0Hz to 60Hz during operation
Screen at power-ON
1.
The monitor display appears.
Operation mode change
2.
Press
to choose the PU operation mode. PU indicator is lit.
Selecting the setting dial mode
3.
Change the Pr. 160 setting to "0" and the Pr. 161 setting to "1".
(Refer to page 5 for change of the setting.)
Start
4.
Press
to start the inverter.
Frequency setting
5.
Turn
until "
You need not press
REMARKS
 If blinking "60.00" turns to "0.00", the Pr. 161 Frequency setting/key lock operation selection setting may not be "1".
 Independently of whether the inverter is running or at a stop, the frequency can be set by merely turning the
(Use Pr. 295 Magnitude of frequency change setting to change the frequency setting increments of
NOTE
 When setting frequency by turning setting dial, the frequency goes up to the set value of Pr. 1 Maximum frequency
(initial value: 120Hz). Adjust Pr. 1 Maximum frequency setting according to the application.
25
Operation
" (60.00Hz) appears. The blinking frequency is the set frequency.
.
.
.)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents