Ending A Conference Call - Sennheiser DW 800 Instructions For Use Manual

Advanced settings
20
Within one minute after the last mobile unit was
placed into the docking station:
If an additional mobile unit is to participate in the
conference call, place it into the
charging slot of the docking station.
The mobile unit starts beeping the same way as the
master mobile unit, indicating that the mobile unit
has joined the conference call.
Repeat the last step for up to three mobile units.
Press the program key
and keep it pressed for four seconds.
All mobile units stop beeping. The conference
initialization mode is ended and the conference call
begins.
Note:
The conference
automatically one minute after the last mobile unit
is placed into a charging slot or the maximum
number of participating mobile units is reached.

Ending a conference call

To make a mobile unit leave the conference call:
Press the hook key
unit.
The remaining mobile units continue to participate
in the conference call.
Note:
Once a mobile unit leaves a conference call, re-entry
is impossible. The whole call has to be set up again
from the beginning.
on the master mobile unit
initialization mode
on the corresponding mobile
right-hand
ends