Honeywell HDZ302D User Manual page 77

To enable face detection:
1. Select the Enable check box.
2. Next to Alarm Period, click Setup. The Alarm Period window opens.
3. Set the days and times when you want the alarm function to be active, and then click
Save.
4. To enable face enhancement, select the Enable Face Enhancement check box.
5. To start recording video when an event is detected, select the Record check box.
6. In the Record Delay field, enter the number of seconds that the system will continue to
record video after the event has ended. Enter a value between 10 and 300.
7. To generate an alarm output when an event is detected, select the Alarm Output check
box and select the alarm output(s) to be activated.
8. In the Alarm Delay field, enter the number of seconds that the system will continue to
generate an alarm output after the event has ended. Enter a value between 10 and 300.
9. To send an email notification when an event is detected, select the Send Email check
box. Email settings must be configured in Setup > Network Setup > SMTP (Email). See
Configuring Email Settings
10. To initiate a predefined preset, tour, or pattern when an event is detected, select the PTZ
check box and select the desired action from the Activation list.
11. To take a snapshot when an event is detected, select the Snapshot check box.
Note For the snapshot to be attached to the email notification, the Attachment check
box must be selected in Setup > Network Setup > SMTP (Email).
See Configuring Email Settings
12. Click Save to apply the settings.
on page 59.
on page 59.
Configuring Event Settings | 77
800-22456 - A - 04/2017