Configuring Powerup Settings; Configuring Tilt Limits; Configuring Time Tasks - Honeywell HDZ302D User Manual

Configuring PowerUp Settings

You can set up the camera to perform a specific action when it is powered up.
To enable PowerUp settings:
1.
2.
3.
4.

Configuring Tilt Limits

You can set upper and lower tilt limits for the camera.
To set tilt limits:
1.
2.
3.
4.

Configuring Time Tasks

You can set up the camera to perform specific actions only within a specified period.
To set up a time task:
1.
2.
3.
In the PowerUp area, select the Enable check box.
Next to PowerUp, select the action that you want
the camera to perform when it is powered up. Click
Preset, Tour, Scan, Pattern, or Auto. If Auto is
selected, the camera will go to its last position
before it was powered down.
If Preset or Scan is selected, in the Number box,
select the number of the preset or scan.
Click Save to apply the settings.
In the PTZ Limit area, select a maximum tilt
angle for the camera from the Max
Elevation list.
Using the PTZ controls below the preview
window, move the camera to the upper tilt
limit and then, next to Up Line, click Setup.
Move the camera to the lower tilt limit and
then, next to Down Line, click Setup.
Select the Enable check box to enable the
tilt limit function.
After the function is enabled, click Live to go to the upper or lower tilt limit.
In the Time Task area, select the Enable
check box.
Select the time task that you want to
configure from the Time Task No. list.
You can configure up to 4 time tasks.
Next to Time Task Action, select the
action that you want the camera to
perform during the specified period.
Click Preset, Tour, Auto Scan, or
Pattern.
PTZ Operation | 31
800-22456 - A - 04/2017