Set Valid Times; Time Definitions - 3M XT-1 Operating Instructions Manual

Appendix: Timer Module

Set Valid Times

Time Definitions

January 2012 – Revision 1.8
Page 62 of 71
2. Select
3 Set Goal Times
You can set goal times for every report period that is available in the
timer: full day reports, day part reports, and shift reports.
•
FULL DAY Reports
•
7 Days of the week
•
DAY PART Reports
•
8 day parts
•
SHIFT Reports
•
4 shifts
For each of these time period selections, you can then set goals for the
detector or report group available.
•
Any of 6 Detector Inputs, or
•
Any of 6 Report Groups, or
•
The Greet event
Note:
Goal times are always set in mm:ss format
Perform the following procedure to change the Valid Times:
1. Enter the timer configuration menu, see above.
2. Select
3 Set Valid Times
"Valid times" refers to the part of the day that the Timer System is
active. Outside that period, the XT-1 system ignores all vehicle
detection signals and records no data.
Valid Time is usually set to match the store's working schedule, but it
can also be configured to allow monitoring of after hours drive-thru
traffic.
Start and End Times for each day are set independently.
If a store is open 24 hours a day, then the valid times Start and End can
be set to the same value. Any value works except "00:00". Start 00:00
and End 00:00 is reserved for a store that is closed all day. So, to
indicate a store that is open 24 hours a day, we could use Start 00:01
and End 00:01.
Perform the following procedure to change the Time Definitions:
1. Enter the timer configuration menu, see above.
2. Select
5 Time Definitions
.
.
.
3M™ Wireless Communication System Model XT-1
Operating Instructions