Operation; Headsets; Overview; Component Identification And Description - 3M XT-1 Operating Instructions Manual

Headsets

Overview

T2
Volume Down
Page
T1
3M™ Wireless Communication System Model XT-1
Operating Instructions

Operation

This chapter provides instructions for using headsets with an 3M™ Wireless
Communication System Model XT-1 after the system has been installed,
configured, and powered on.

Component Identification and Description

Indicator LED
Volume up
Figure 2
•
Adjustment Slide: Push or pull to adjust for a comfortable fit.
•
Indicator LED: Indicates operating status of the headset. See
Indicator Light Modes below.
•
T1 and T2 (Talk:buttons): Connect you to the order point.
1. When there are two order points, T1 connects to order point 1
and T2 connects to order point 2.
2. When there is only one order point, T1 and T2 both connect to
the order point.
3. If you are in Manual Latching or Hands Free modes, the talk
button establishes you as the order taker; and while you are the
order taker, the talk button is an order point mute button (each
tap turns mute on or off to the order point).
•
On/Off: Turns the headset on and off. Hold for 3 seconds to turn off.
•
Volume: The up button increases volume, the down button decreases
volume.
•
Page: Has several functions related to in-store communication:
1. Talk to all headsets on the same lane (or both lanes depending
upon the configuration), but not to the order point. Press and
hold the page button during normal operation to communicate
with other headsets. There is an option in Global settings to
allow the order taker to hear or not to hear page messages.
Adjustment
Slide
On/Off
January 2012 – Revision 1.8
Page 29 of 71
Operation
Battery
Release