Built In Mic
Ensemble features a built-in mic on the front panel that can be recorded, or used for the Talkback function
34)�
Recording the Built-In Mic
Ensemble's Built-In Mic can be recorded into your computer in the same way as the other inputs on the
Ensemble�
•
Because Ensemble requires inputs to be assigned as pairs, the Built-In Mic is assigned to channels 9/10�
•
Even though the mic assigned to two channels, it is not stereo� Instead the mono signal is duplicated to both
channels�
•
In your DAW, set the track's Input Source to Channel 9 or Channel 10�
•
The Built-In Mic gain is controlled from the Mix View of the Primary window in Apogee Control
Analog Audio Outputs
Ensemble provides 16 analog outputs for connecting to your external gear�
Monitor Out L1 & R2
Ensemble's Monitor Out L1 & R2 are designed to connect to studio monitor speakers� These outputs
are controlled by the Output Controller knob, but can be set to a fixed line-level output via the Device
Sidebar of the Apogee Control software� See the Monitor Control Center section on
information on configuring these outputs.
•
Balanced 1/4 TRS outputs
•
Can be configured as a fixed line-out
•
Can be set to +4dBu or -10dBV via the Apogee Control software
Analog Out 3-10
adjusted by the Output Controller knob when multiple speaker sets
37) is enabled� See the Monitor Control Center section on
outputs�
•
Balanced 25-pin D-Sub Output
•
Can be set to +4dBu or -10dBV via Apogee Control
Ensemble provides additional balanced analog outputs via a 25-pin d-sub connector�
Connect an analog out breakout cable to this connector to access these outputs�
These outputs are set as fixed line-level outputs by default, but outputs 3-10 can be
Apogee Ensemble Thunderbolt | User's Guide
(page
49)
(page
36) or 9�1 surround monitoring
page 36
for more information on configuring these
(page
49)
32
(page
(page
45)�
page 36
for more
(page