Fluke 810 User Manual page 142

810
Users Manual
Display Message
Failed to perform self test
Data transfer not successful
Contact Fluke Service
Center
Display Message
Application encountered an
error.
Invalid file
Installation file format is
wrong
Tester connection is lost
B-4
Table B-1. Vibration Tester Warning and Error Messages (cont.)
This message shows during the self-test. The Tester is defective. Contact the Fluke Service
Center for technical support.
This message shows if the Tester cannot connect to the Viewer software. Make sure that the
connection is good between the Tester and computer.
An error occurred in the Tester. Turn the Tester off and then on. If the message is frequent,
contact the Fluke Service Center for technical support.
Table B-2. Viewer Software Warning and Error Messages
An error occurred in the Viewer software. Restart the Viewer software application.
The Viewer software cannot read the file type.
The upgrade file is defective or invalid.
This message shows if the connection breaks between the computer and the Tester during
data transfer. Correctly connect the USB cable.
Description
Description