Table of Contents
Advertisement
1.0 IMPORTANT SAFETY INSTRUCTIONS
- Misuse of this machine can cause serious
injury.
- For safety, machine must be set up, used and
serviced properly.
- Read, understand and follow instructions in the
Operating Instructions and Parts Manual which
was shipped with your machine.
When setting up machine:
- Always avoid using machine in damp or poorly
lighted work areas.
- Always be sure the machine support is
securely anchored to the floor or the work
bench.
When using machine:
- Always wear safety glasses with side shields
(See ANSI Z87.1)
- Never wear loose clothing or jewelry.
- Never overreach—you may slip and fall.
1.
Always wear protective eye wear when
operating machinery. Eye wear shall be impact
resistant, protective safety glasses with side
shields
which
comply
specifications. Use of eye wear which does not
comply with ANSI Z87.1 specifications could
result in severe injury from breakage of eye
protection.
2.
Wear proper apparel. No loose clothing or
jewelry which can get caught in moving parts.
Rubber soled footwear is recommended for
best footing.
3.
Do not overreach. Failure to maintain proper
working position can cause you to fall into the
machine or cause your clothing to get caught,
pulling you into the machine.
4.
Keep guards in place and in proper working
order. Do not operate the machine with guards
removed.
5.
Avoid dangerous working environments. Do not
use stationary machine tools in wet or damp
locations. Keep work areas clean and well lit.
6.
Avoid accidental starts by being sure the start
switch is "OFF" before plugging in the machine.
1.1 Machinery general safety warnings
with
ANSI
Z87.1
When servicing machine:
- Always disconnect the machine from its
electrical supply while servicing.
- Always
follow
Instructions and Parts Manual when changing
accessory tools or parts.
- Never modify the machine without consulting
JET.
You—the stationary power tool user—hold the
key to safety.
Read and follow these simple rules for best results
and full benefits from your machine. Used properly,
JET machinery is among the best in design and
safety. However, any machine used improperly can
be rendered inefficient and unsafe. It is absolutely
mandatory that those who use our products be
properly trained in how to use them correctly. They
should
read
and
Instructions and Parts Manual as well as all labels
affixed to the machine. Failure to follow all of these
warnings can cause serious injuries.
7.
Never leave the machine running while
unattended. Machine shall be shut off whenever
it is not in operation.
8.
Disconnect electrical power before servicing.
Whenever changing accessories or general
maintenance is done on the machine, electrical
power to the machine must be disconnected
before work is done.
9.
Maintain all machine tools with care. Follow all
maintenance instructions for lubricating and the
changing of accessories. No attempt shall be
made to modify or have makeshift repairs done
to the machine. This not only voids the warranty
but also renders the machine unsafe.
10. Machinery must be anchored to the floor.
11. Secure work. Use clamps or a vise to hold work,
when practical. It is safer than using your hands
and it frees both hands to operate the machine.
12. Never brush away chips while the machine is in
operation.
13. Keep work area clean. Cluttered areas invite
accidents.
14. Remove adjusting keys and wrenches before
turning machine on.
2
instructions
in
Operating
understand
the
Operating
Advertisement
Table of Contents
