Quick Shift System - Yamaha MTN850-AH Owner's Manual

Special features
Resetting the traction control sys-
1
tem
The traction control system will auto-
2 matically disable when:

the front wheel or rear wheel
comes off the ground while riding.
3

excessive rear wheel spin is de-
tected while riding.
4

either wheel is rotated with the key
turned to "ON" (such as when per-
forming maintenance).
5
If the traction control system is dis-
abled, both the " " indicator light and
6
the " " warning light will come on.
Should this occur, try resetting the sys-
7
tem as follows.
1. Stop the vehicle and turn the key
to "OFF".
8
2. Wait a few seconds and then turn
the key back to "ON".
9
3. The " " indicator light should turn
off and the system be enabled.
10
TIP
If the " " indicator light remains on af-
11
ter resetting, the vehicle may still be rid-
den; however, have a Yamaha dealer
check the vehicle as soon as possible.
12
4. Have a Yamaha dealer check the
vehicle and turn off the "
ing light.
4-3
" warn-

Quick shift system

The quick shift system (QS) allows for
full-throttle, clutch lever-less, electroni-
cally-assisted upshifts. When the shift
switch detects motion in the shift pedal
(page 5-14), engine power and drive
torque are momentarily adjusted to al-
low the upshift to occur.
TIP

The quick shift system operates
when traveling at least 20 km/h (12
mi/h) with an engine speed of 2300
r/min or higher, and only when ac-
celerating.

It does not operate when the clutch
lever is pulled.
EAU76401