T+A CARUSO BLU User Manual page 70

Dropouts occur during
playback.
Streaming Client
The streaming client can
not connect to a network.
On the display the indication
'SCL Connecting...'
is displayed.
70
Cause 1:
The distance to the  is too great (>6 metres), or there are obstacles
between the  and the mobile device which affect reception.
Remedy:
Reduce the distance to the , and avoid obstacles - such as persons -
between the devices.
Cause 2:
The radio connection is suffering interference from other radio networks (e.g.
WLAN, baby intercom, etc.) which may already be in use.
Remedy:
If possible, switch to the USB input or the Streaming Client.
Cause 1 (cable LAN):
Network cable not properly connected
Remedy:
Connect network cable, check connection to router
Cause 2 (cable LAN):
The router uses energy-saving functions, causing it to switch the LAN port on
with a delay, with the result that the  makes no connection - or only a
sporadic connection - during the power-on process.
Remedy:
In the menu for the SCL source (hold the SRC button pressed in) change the
"Network IF mode" menu point to "Lan only". This ensures that only the wired
network connection is used.
Cause 3 (wireless LAN):
WLAN antenna not connected or placed in a location with bad reception quality
Remedy:
Connect WLAN antenna properly and find a location with good reception
quality.
Set the transmission power output of your WLAN router to maximum.
Try to establish a network connection first in a location close to the WLAN
router. If this succeeded try to connect to WLAN from a more remote location.
Experiment with antenna position and try to find a location with better reception
quality.
Cause 4 (wireless LAN):
WLAN reception quality bad (low field strength). Possibly too much attenuated
by walls/ceilings on the transmission path.
Remedy:
Optimize location of receiver and transmitter antennas.
Alternative:
If transmission problems persist a so called ‚Power Line' network might be good
alternative to establish a good and stable network connection.
The best, safest and most secure network however will always be a cable LAN
network.
Cause 5 (wireless LAN):
Although the router has been selected, and the WLAN password has been
entered correctly, no connection to the network is created.
Remedy:
Some routers are set by default to two simultaneous WLAN protocols
(WPA / WPA2). Set your WLAN router to just one type of protocol, e.g. WPA2.
Cause 6:
Network parameters not properly configured.
Remedy:
Configure the network
configuration').
Cause 7 (operation without network connection):
For proper operation the  needs at least one properly connected
network device. This can be a LAN or WLAN network or a USB storage device.
Remedy:
If the  shall be operated without network (LAN / WLAN) please connect
at least a USB stick.
parameters correctly (see chapter 'Network