The Configuration for a WLAN connection
Setting the Parameters for a
Radio Network
Searching for and Selecting
the Network
Entering the Password
(for encoded networks)
Connect the WLAN aerial (supplied) to the WLAN aerial socket, and
ensure that no cable is attached to the LAN socket.
Switch the on, and select the Streaming Client function by pressing
the button.
Now call up the Configuration menu as described above: with a long press on
the button. You should now see the menu reproduced below, dis-
playing the network parameters.
First select the menu point 'WLAN configuration start', and activate it by
pressing the button.
A menu appears showing these points:
Rescan
- initiates new search for accessible radio networks
Set manually - adding a WLAN manually
After a brief delay the networks present in the vicinity are listed on the screen.
You can use the 'Rescan' function to start a new search for networks present in
the vicinity.
Please select one of the networks located, and activate it by pressing the
button.
If your network is encoded, the window illustrated above now appears. Please
enter the network password and confirm the entry by pressing . Now
select the point 'Save WLAN settings' and confirm with .
If a WEP code is used, the password must be entered as a hexadecimal code
(0 - 9, A - F).
Please enter the settings for the remaining network parameters as described
earlier in the section entitled 'Setting the Parameters for a Wired Network'.
Possible entries
49