Table of Contents
Advertisement
System settings (System Configuration Menu)
The System Configuration menu is used for adjusting the general settings of the machine. This menu is described in
detail in the following chapter.
Calling up and operating
the menu
Menu point
Tone
Menu point
Source configuration
Sub-point
TV
Sub-point
Auto power-on
42
The menu is called up by briefly pressing the button on the front
panel or the remote control handset.
Once the menu is open, the following select points appear on the screen:
Use the / buttons to select a menu point.
If you wish to change a selected menu point, first press the button,
then change the value using the / buttons.
To accept the change, press the button again after altering the
setting.
To quit without accepting a changed value, you can interrupt the procedure
at any time by pressing the button.
Press the button again to leave the menu.
Using this menu point you can access the Tone menu by pressing the buttons
on the .
This menu can also be called up directly by pressing the button on the
FM100 remote control handset.
When you call up this menu point using the button, a list of all the
external sources of the appears. You have the opportunity to alter
external sources.
Some TV sets feature optical (TOSLINK) digital outputs. If you wish to use the
with such a set, you can assign the optical digital input D3 to the TV
source of the instead of the analogue sound input A2. In this case the
accepts and processes the digital stereo signal (PCM signal) from the
source device instead of the analogue signal. Set the input matching your TV
set at this point.
If a digital input (e.g. D3) is assigned to the TV source, then that input is no
longer available as a separate source.
This menu point enables you to automatically switch on the due to the
automatic power-on function.
If this function is switched on, the automatically switches itself on from
standby mode, and switches to the selected source (if necessary), when a
music signal is present at the A1, A2, D1 ,D2, or D3 input - depending on the
input to which the auto power-on source is assigned.
If the is switched on, but no signal is detected at the auto power-on
input within about twenty minutes, then the automatically switches
itself off again; however this only occurs if the auto power-on source is
selected.
In this mode of operation the volume control for the selected source is
separate, i.e. the volume level for this source is stored separately, and only
changes when the auto power-on source is selected.
This makes it possible to pre-set a fixed volume at the , and to control
the volume, for example, using the TV set connected to the system.
Of course, the volume can also be controlled using the , and the TV
set left at a fixed level.
The auto power-on function is only supported in 'Comfort standby' or 'App
standby''.
Advertisement
Table of Contents
