Table of Contents
Advertisement
Software update generally
Automatic software update
Important notes
66
Software update
Software updates keep your up-to-date. They bring new optimisations
like faster operation and new features which could be developed in the future.
It may occur that after a software update some of your user defined settings
like network parameters or favourite stations are lost and have to be restored
after the update.
If the is connected to the internet it will periodically check if a new
software version is available. In case a new version is found, your Music
Receiver will inform you on its display at the time it is switched OFF.
If this happens you have three choices which can be selected by the
and buttons. A press on the button will execute your selection.
The update will be downloaded from the internet and installed.
"Yes"
The will switch OFF automatically after the update is
complete.
"No"
This software update is ignored and not installed. You will be
asked again when the next software version is available.
"Later"
The update information will be automatically displayed again
after a while giving you the possibility to carry out the update at
a later time.
If an error message appears when an update is being loaded - perhaps due to
a poor WLAN connection - and the update is interrupted, the should
be connected to a wired network (LAN), and the update restarted.
Depending on the point at which the error in the update process occurred, you
may find that the starts with the previous version of the software, or
switches on immediately with the message that the update must be loaded
again from a USB stick or the Internet.
In the first case the update can be started manually using the software update
menu. You will find a detailed description under www..
In the second case the update can be repeated simply by pressing the
button. It is possible to disconnect the device from the mains in order to
connect it somewhere else using a LAN.
In both cases the update should be carried out using a wired network (LAN) in
the interests of safety.
Updating the disc drive (Servo Firmware)
The servo software of the disc drive can be updated via a USB stick. The
Caruso checks the software version of the drive regularly. Once a newer than
the installed version is available, the following message appears on the display
(only at the source 'disc'):
'Servo firmware update available'
If this message appears, the servo software should be updated. The update
process is described in the Service Note 111. The instructions and the latest
firmware are available on our homepage:
http://www.ta-hifi.com/caruso-blu-servo-software
Advertisement
Table of Contents
