Reprogramming your locomotive to restore features Maintaining and servicing your locomotive Lubricating your locomotive Servicing your locomotive’s LED Limited Warranty/Lionel Service The following Lionel marks may be used throughout this instruction manual and are protected under law. All rights reserved. Lionel ® , TrainMaster ®...
Do not power your locomotive with direct current (DC). Damage to Caution! sensitive electronic components may occur. 3. Move ‘em out! Get your train moving. Press the DIRECTION button on your Lionel transformer. This sequences the Command reverse unit in the powered locomotive to the next operating state. Note!
B-unit’s rear ElectroCoupler. The magnetic coupler on the rolling stock will then react to the magnetic field generated by a Lionel Remote-Control or Uncoupling Track section (available separately, 6-65530 for O gauge; 6-65149 or 6-12746 for O-27 gauge;...
TrainMaster Command Control operations TrainMaster Command Control operations rainMaster Command Control is the advanced model railroad control system from Lionel. To operate your locomotive in the Command Control environment, you need a Command Base (available separately, 6-12911) and a CAB-1 Remote Controller (available separately, 6-12868).
TrainMaster Command Control operations CAB-1 Remote Controller commands for your locomotive Press DIR—the back-up light turns on when the unit is in reverse. Rear coupler releases. Beneath this panel...
TrainMaster Command Control operations Assigning your locomotive a new ID# s your roster of TrainMaster Command Control-equipped locomotives grows, you will want to give each unit a unique ID#. The locomotive will respond to commands associated with its ID# while all other units will disregard these commands. To restore your locomotive’s functions, see page 9.
TrainMaster Command Control operations Building a lash-up hen your non-powered locomotive has been programmed as part of a lash-up with a number of Command-equipped powered or non-powered locomotives, the locomotives will respond together, allowing the headlights and back-up lights to operate prototypically. The direction of the train will indicate which headlights are on.
TrainMaster Command Control operations Reprogramming your locomotive to restore features f your locomotive is unresponsive to your commands in the TrainMaster Command Control environment, we recommend that you follow this procedure to reset your locomotive. 1. Slide the Command reverse unit switch to the PGM position. 2.
We recommend that you purchase a Lionel Lubrication and Maintenance Kit (6-62927), available from your Lionel dealer. Two basic rules to keep in mind: never over-lubricate (a small amount will do), and avoid getting grease or oil on the locomotive’s wheels or your track.
LED which is expected to last for the life of the locomotive. Only an authorized Lionel Service Center should service the locomotive’s LED. See the Lionel Service section on page 12 for more information.
Lionel L.L.C. or an authorized Lionel L.L.C. Service Center, together with proof of original purchase will, at the option of Lionel L.L.C., be repaired or replaced, without charge for parts or labor. In the event the defective product cannot be repaired, and a replacement is not available, a refund of the original purchase price will be granted.
Need help?
Do you have a question about the 2343c Non-PoweredF-3 B-Unit and is the answer not in the manual?
Questions and answers