Building A Lash-Up - Lionel 2343c Non-PoweredF-3 B-Unit Owner's Manual

TrainMaster Command Control operations

Building a lash-up

W hen your non-powered locomotive has been programmed as part of a lash-up with a
number of Command-equipped powered or non-powered locomotives, the locomotives
will respond together, allowing the headlights and back-up lights to operate prototypically.
The direction of the train will indicate which headlights are on.
To build a lash-up, assign a unique engine (ENG) ID# to each unit. Arrange the units on
the track and couple them together. The Command reverse unit switches must be set to
RUN/FORWARD.
If you press a wrong button, start over with that particular unit. The assignment
Note!
isn't saved until you press SET on the CAB-1 Remote Controller.
Start with the powered A-unit.
1. On your CAB-1 Remote Controller, press TR, then enter your lash-up ID# (1-9).
No other track or lash-up should be assigned that ID#.
Note!
2. Enter the lead unit's unique ID#, then press F.
3. Press SET beneath the front panel of the CAB-1 Remote Controller.
Complete the lash-up by adding the non-powered B-unit.
1. On your CAB-1 Remote Controller, press TR, then enter your lash-up ID# (1-9).
2. Enter the B-unit's unique ID#.
3. Press SET beneath the front panel of the CAB-1 Remote Controller.
Only the ElectroCouplers at the front of the lead unit and at the rear of the last unit
Note!
will operate when the locomotives are addressed as a lash-up. Any ElectroCouplers
located between the locomotives will not function when you address the lash-up.
You are now ready to operate your locomotives as a lash-up. Simply press TR and enter the
lash-up ID#, then use the CAB-1 Remote Controller to operate your locomotives. To operate an
individual unit within the lash-up, simply press ENG and enter the ID# for that unit.
8