Table of Contents
Advertisement
The Motorola Cellular Gateway NC800's Back Panel
The Motorola Cellular Gateway NC800's back panel contains the following connectors (from left to right):
A WLAN antenna is connected to either side of the Motorola Cellular Gateway NC800.
WLAN antenna
These antennas provide wireless access to the Motorola Cellular Gateway NC800 for
devices equipped with 802.11b/g modules.
The Reset button can be used in one of two ways:
Reset Button
•
•
A diagnostics port for maintenance support use only.
DIAG 1 Port
A diagnostics port for maintenance support use only.
DIAG 2 Port
This is a connector for the external CDMA antenna. It provides access to the Internet
WAN Antenna
through a CDMA base station. CAUTION: Only the provided external antenna should
be mounted.
This is an 802.3 10/100Mbps Full/Half Duplex LAN interface. It provides wired access
LAN 1 Port
to the Motorola Cellular Gateway NC800 for devices equipped with 802.3 LAN
modules. Use this port to connect to network devices such as a computer, printer, hub,
switch or gateway. You can connect either a straight-through or crossover cable to the
port – the Motorola Cellular Gateway NC800 will detect the cable configuration and
reconfigure itself accordingly.
This is an 802.3 10/100Mbps Full/Half Duplex LAN interface. It provides wired access
LAN 2 Port
to the Motorola Cellular Gateway NC800 for devices equipped with 802.3 LAN
modules. Use this port to connect to network devices such as a computer, printer, hub,
switch or gateway. You can connect either a straight-through or crossover cable to the
port – the Motorola Cellular Gateway NC800 will detect the cable configuration and
reconfigure itself accordingly.
This is where you connect the power adapter. Please make sure that you use only the
Power
power adapter that is shipped with the Motorola Cellular Gateway NC800.
A WLAN antenna is connected to either side of the Motorola Cellular Gateway NC800.
WLAN antenna
These antennas provide wireless access to the Motorola Cellular Gateway NC800 for
devices equipped with 802.11b/g modules.
Motorola Cellular Gateway NC800 User Guide Version 2.0
Figure 6. Motorola Cellular Gateway NC800 back panel
Reboot the Motorola Cellular Gateway NC800 while keeping all of its settings. This
is similar to pressing the Reset button on your PC to reboot it.
Restore the Motorola Cellular Gateway NC800's factory default settings. If you are
experiencing problems with the Motorola Cellular Gateway NC800 and have tried
all other troubleshooting measures, press the Reset Button and hold it down for
10 seconds. This will restore all settings, including your new password and IP
address, to the factory default settings. Refer to Factory Default Settings for the
Motorola Cellular Gateway NC800 for more detail.
Page 14 of 110
Advertisement
Table of Contents
