10_Installing The Computer; 10_Assembling The Handlebars - Keiser M3i Installation And Operation Manual

M3i INDOOR GROUP CYCLE
INSTALLING THE COMPUTER
1. Use a #2 Phillips screwdriver and remove the
computer mounting screw from the handlebar tube,
refer to Figure 11.
2. Coil the computer cable into the computer mount
cavity, refer to Figure 12.
Figure 11. Remove Mounting Screw From Handlebar Tube
ASSEMBLING THE HANDLEBARS
1. Remove screws from both sides of the sweat guard,
refer to Figure 13.
2. Slide on the guard cover over the sweat guard and
Figure 13. Remove Screws From Sweat Guard
555518_A
OPERATION
3. Slide the computer in the two locking ears.
4. Insert and secure the computer with the screw
previously removed using a #2 Phillips screwdriver.
Figure 12. Attaching the Computer to the Handlebar Tube
snap it in place, refer to Figure 14.
3. Secure the cover with the screws previously removed.
Do not over tighten screws.
Figure 14. Align the Guard Cover Over the Mounting Holes
p10.