Table of Contents
Advertisement
C. Dip switch Programming
1. Auto Answer ON/OFF (DIP Switch 1)
DIP switch 1 is for turning the Auto Answer feature ON and OFF. The E-70 is factory set to auto
answer when an inbound call is detected.
2. Dial Tone Detection ON/OFF (DIP Switch 2)
With DIP switch 2 in the ON position, if the
dial tone, the unit will automatically disconnect. If the E-70 is installed on a continuously noisy
line, it may detect the noise as dial tone and automatically disconnect. If this happens, turn the
dial tone detection (DIP switch 2) OFF.
3. Programming Mode ON/OFF (DIP Switch 3)
With DIP switch 3 in the OFF position, the E-70 is in the "Normal Operation Mode" (factory
setting). By placing DIP switch 3 in the ON position, the E-70's programming mode is enabled.
The programming mode is used for adjusting the Call Length Time Out, Silence Time for
automatic disconnect and the Talk/Listen delay (VOX switching speed). These features are set
from the factory and normally do not need adjustment. If adjustment is necessary, see
Programming sections D - I.
4. LED ON/OFF (DIP Switch 4)
With DIP switch 4 in the ON postion, the blue faceplate LED will remain on at all times (to help
locate push button switch in dark locations), dim to indicate off hook and flash to indicate
incoming ring. When connecting an E-70 to a C.O.line, turn the LED off to comply with FCC
regulations.
Switch
1
1
2
2
3
3
4
4
D. Accessing the Programming Mode
The E-70 can be programmed from any Touch Tone phone using a telephone line, Viking model C-
200, C-250 or C-2000B Entry Phone Controller, analog PABX/KSU station or a Viking model DLE-
200B Line Simulator.
Step 1
Move DIP switch 1 to ON (Sets unit to answer incoming calls, see Section C).
Move DIP switch 3 to ON (incoming calls automatically enter the programming mode,
Step 2
see Section C).
Step 3
From a touch tone phone call the line attached to the E-70.
When the E-70 answers, 2 beeps will indicate that you have accessed the
Step 4
programming mode.
When finished programming, enter "0000" to exit programming and move DIP switch
Step 5
3 to the OFF position.
Position
Description
ON
Auto Answer ON (factory setting)
OFF
Auto Answer OFF
ON
Dial Tone Detection ON (factory setting)
OFF
Dial Tone Detection OFF
ON
Programming Mode
OFF
Normal Operation Mode (factory setting)
ON
LED ON (factory setting)
OFF
LED OFF
E-70 detects more than 5 seconds of continued
7
Advertisement
Table of Contents
