Viking E-70-BK Product Manual page 4

D. Mounting the Faceplate
After the Rough-In box or VE-5x5 is securely mounted, caulking between the box and rough opening
is completed (if required), and wires are connected, remove paper liner from face plate gasket back
and place it on back side of the faceplate aligning with push button hole. Push the 1-1/4" 6-32
screws through faceplate holes and small holes in gasket, the faceplate gasket should retain the
screws. Position Circuit board mounting plate over screws. Align screws with double gang box
bosses and tighten face plate until gasket is fully collapsed and the push button is protruding through
the clearance hole in the face plate. Included 1/4" thick gasket will provide an adequate seal for
most siding surfaces; however for rough surfaces (ie: brick, stucco, etc.) additional caulking may
be required.
Wing Brackets
Belden
9537
Cable
*2.25"
Deep
Min.
"Old Work" Double Gang Rough-In Box
with minimum dimensions of:
3.65"W x 2.84"H x 2.25"D
. (Carlon BH234R box shown, not included)
-OR-
5.22"
5.14"
2.25"
Optional VE-5x5 Surface Mount Box
with Black Satin Powder Paint Finish,
not included (DOD# 424)
WARNING: Do NOT use a wet location box.
* CAUTION: Excessive wire length and/or using a rough-in box with inadequate depth can apply force to the
circuit board causing physical damage.
** Important: Push LED light pipe into faceplate hole, then place faceplate upside down on a clean flat surface
and push down on back side of plate until light pipe is fully seated and straight. WARNING: Inserting the light
pipe more than one time can cause a loose fit
4
(9) 3-Wire Gel-Filled
Butt Connectors
(included)
Wires from
Phone Board
W/BL
CAT5E
Cable Green
BL/W
Red
Wires from
Proximity
Card Reader
Black
Black
Red
Red
Green Green
White
White
3.25"
(2) Junction Box to
Double Gang Adapter
Plates and (4) 5/64 Hex
Drive Flat Head Screws
3.63"
(included with the E-70)
3.63"
Circuit Board
1/4" Thick Foam
Mounting Plate
Faceplate Gasket
(included)
.
(included)
(included)
Optional VE-LIGHT Kit can be used
to illuminate the E-70 faceplate,
** LED
Light Pipe
(included)
(4) 6-32 x 1.25" Long
5/64" Hexdrive
Facplate
Flathead Screws
(included)
see DOD# 428.