Table of Contents
Advertisement
32
Power Up Procedure
Power Down Procedure
To power up the Lightning system:
1.
Ensure that all peripheral equipment is powered on, including the
SVGA monitor and the ShotBox.
2.
Press the Power switch on the front of the Lightning chassis. The
green Power LED (below the switch) lights when the system is on.
At this point, the system boots up and launches the Lightning
application.
To power down the Lightning system:
1.
Exit from the Lightning application by pressing the standard
Windows "close" box in the upper right corner of the window.
2.
Click Start on the Windows NT Taskbar.
3.
Click Shut Down... to display the Shut Down dialog box.
4.
Select the "Shut down the computer" radio button.
5.
Click Yes. The system writes unsaved data to disk, then displays
the Shutdown Computer dialog box.
6.
Press the Power switch on the front of the Lightning chassis to shut
down the system.
Lightning 1000 Installation Guide
Advertisement
Table of Contents
