6
Inputs
Video
Key
Video
Key
Video
Lightning
A Word About Windows NT
Remote Control
The Lightning system can be controlled remotely via GPI, RS-422 automa-
tion or OLE commands.
System Inputs and Outputs
A Lightning system can be configured with a maximum of three CCIR-601
Input/Output channels as shown below:
Channel
1
Key
Chassis
Note that each channel has one input which is 4:2:2:4—video plus key
(4:2:2 on the video input connector; 4:0:0 on the key input connector).
Refer to Chapter 2, Hardware Installation for complete I/O details.
The Lightning system runs in the Windows
assumes that you are comfortable with standard Windows-based proce-
dures, such as using Dialog Boxes. These procedures will not be discussed
in this guide. If you are not familiar with Windows NT, refer to your
Windows NT User's Guide or to one of the many third-party books on the
subject.
Lightning 1000 Installation Guide
Channel
2
Channel
3
™
NT environment. This guide
Outputs
Video Out
Key Out
Video Out
Key Out
Video Out
Key Out