Reference Connection - Pinnacle Systems Lightning 1000 Installation Manual

26
Note
Reference Out
Terminator
Reference Out

Reference Connection

To connect video reference:
1. Connect a stable analog reference signal (such as Black Burst)
from your house sync generator to the left-hand Reference
connector.
The house sync generator must feed the same reference to all devices in
your Lightning system.
2. If Lightning is the last device in your reference loop, terminate the
right-hand Reference connector with a 75-ohm terminator as
shown below.
Loop
Loop
75 Ohm
3. If Lightning is in the middle of your reference loop, connect the right-
hand Reference connector to the next device's reference input connector, as
shown below
Loop
Loop
Loop
to next
device
Lightning 1000 Installation Guide
Sync Generator
VTR 1
VTR 2
Lightning
Sync Generator
VTR 1
Lightning
VTR 2