Notes On Installing Receiver (Anti-Noise Measures) - Ko Propo EX-5UR Instruction Manual

Notes on installing receiver (anti-noise measures)

Locate antenna cable as far away from noise source!
Be careful of noise!
Assume that all areas where large currents are
flowing are generating noise! Locate antenna cables
and receiver as far away from the motor, ESC,
silicone cords as possible. (Materials such as metal
or carbon chassis also conduct noise)
R/C model is controlled by radio wave. Therefore,
anti-noise measures are the most important factor.
Take measures to ensure optimum performance of
your R/C model and driving technique.
●Fixing receiver to carbon chassis
When fixing the receiver to the chassis or on the
mechanism deck, use more than 2 layers of double-
sided tape to avoid direct contact with chassis.
Chassis and mechanism deck (especially carbon
material) can also conduct noise. Making space
between receiver with them is recommend to ensure
protection against noise.
※Note receiver LED position when installing.
●Antenna installation
Raise antenna cable vertically and set as high as
possible. Pass cable into antenna pipe to protect
from damage. Be sure that the cable projects a bit
from antenna pipe. Installing antenna holder far away
from receiver may deteriorate radio sensitivity.
Locate antenna holder as near to the receiver as
possible. Make sure that the antenna cable does not
come in direct contact with chassis, mechanism
plate or other noise sources. Make sure to use
plastic antenna pipe and mount. Do not use metal
antenna mount as it easily conducts noise and result
in trouble.
※Do not cut or bundle antenna cable.
(It may result in breaking of wire and deteriorate performance)
Piano wire
Aluminum holder
Soldering lug plate
●Attaching to a gas car
Engine vibration may damage the servo. Make sure to attach
grommet (receiver holder) to reduce vibration. Do not attach
directly to chassis or mechanism plate using double-sided tape.
The installation position should be as far as possible from heat
from engine or exhaust.
※Note receiver LED position when installing.
4
■ Notes on installing receiver (anti-noise measures)
Carbon chassis
receiver
ESC
Plastic antenna pipe
Aluminum holder
FRP or plastic holder
can be used.
Battery
motor
Silicone cords
Double sided tape
Plastic antenna pipe
Plastic holder
Grommet
4