Safety Function; Failsafe Setting - Ko Propo EX-5UR Instruction Manual

Safety function

▶Failsafe setting

Failsafe automatically returns throttle (2ch) in desired position (full brake/neutral) if the model may run out
of control.
① Switch transmitter on.
② Switch receiver on and check servo movement.
③ Operate throttle trigger in brake/neutral position
(transmitter memorizes the position)
④ Hold set button of receiver more than 3 seconds.
Release after LED turns off.
※Failsafe function can be checked by switching
off transmitter. The data will be memorized until
resetting.
※When replacing brake linkage of a gas car,
resetting is recommended.
References
●Model does not work though the transmitter is on
LCD display is displayed with the start sound after switching on. If not, check batteries .
If there is no problem with transmitter, check LED indicator of the receiver.
① In case of the LED is too dark or blinking, it shows conflicting radio signals from other
sources. Change location or take some time before switching on.
②Power is not on if the LED does not shine. Reconnect receiver battery or amplifier cables.
EX-5UR(transmitter) uses 2,4GHz direct sequence spread spectrum (DS-SS) as a frequency
Caution!
band. The frequency band is also used for electric appliances such as personal computer
w/wireless LAN, Bluetooth and microwave oven. In the case of radio interference, LED of
KR-407(receiver) will not turns on correctly. Wait for a while or change location if LED flashes or
lit up incorrectly.
●To increase cornering angle
If steering angle is not enough, adjust steering travel lever to increase travel.
Use"MENU04/05: steering balance"to get more angle.
●To improve steering response
Adjust"MENU07: steering curve"or"MENU06: steering speed"at ＋(quick) side.
●To make steering characteristics milder
Adjust"MENU07: Steering curve"or"MENU06: Steering speed"at −(mild) side.
Adjust"MENU07: Throttle speed at -side.
●To slow down
Adjust"MENU14: Throttle speed"at −side.
Adjust"MENU12: Throttle high point"at −side.
■ Safety function／References
2. Power
4. Set button (hold 3 seconds)
1. Power
3. Throttle trigger
(full brake/neutral)
5. LED (off)
15