Procedure When Running - Ko Propo EX-5UR Instruction Manual

Procedure when running

1.
Power on: Note surroundings and switch transmitter on, then switch receiver on.
2.
Checking model: Confirm model to be used.
※EX-5UR automatically finds unused frequency band after switching on. This function is called "carrier sense". To
perform carrier sense effectively, switching on transmitter around the running area as close as possible.
3.
Checking movements: Raise wheels from ground and operate transmitter to check
movements. Detail adjustment using steering/throttle trim lever should be done while
running. Adjust steering balance by operating 8-figure running.
Stand
4.
Power off: Switch off in receiver, transmitter order and remove running battery.
※Make sure to switch transmitter on and off after an interval of 2 seconds at least.
Functions (1-27)
▶Select using FORWARD/BACK button
※The transmitter automatically memorizes each setting 1
second after changing. When switching transmitter off, wait
more than 2 seconds after changing settings.
MENU01：Steering monitor‥‥‥
MENU02：Steering trim‥‥‥‥‥
MENU03：Steering travel‥‥‥‥
MENU04：Steering balance R‥‥
MENU05：Steering balance L‥‥
MENU06：Steering speed‥‥‥‥
MENU07：Steering curve‥‥‥‥
MENU08：Steering curve‥‥‥‥
MENU09：Steering reverse‥‥‥
6
8-figure running
P.7
P.7
P.7
P.7
P.8
P.8
P.8
P.9
P.9
■ Procedure when running／Functions (1-27)
MENU10：Throttle monitor ‥‥‥
MENU11：Throttle trim‥‥‥‥‥
MENU12：Throttle high point‥‥
MENU13：Throttle brake ‥‥‥‥
MENU14：Throttle speed‥‥‥‥
MENU15：Throttle curve F ‥‥‥
MENU16：Throttle curve B ‥‥‥
MENU17：Throttle sub trim‥‥‥
MENU18：Throttle reverse ‥‥‥
MENU19：ABS power‥‥‥‥‥‥
MENU20：ABS speed‥‥‥‥‥‥
MENU21：3ch monitor ‥‥‥‥‥
MENU22：3ch position setting‥
MENU23：Adjust volume ‥‥‥‥
MENU24：Model reset ‥‥‥‥‥
MENU25：Model copy ‥‥‥‥‥
MENU26：Model name ‥‥‥‥‥
MENU27：Model select‥‥‥‥‥
Trim lever
P.9
P.9
P.10
P.10
P.10
P.11
P.11
P.11
P.12
P.12
P.12
P.13
P.13
P.13
P.14
P.14
P.14
P.14
7