Ko Propo EX-5UR Instruction Manual page 13

MENU21：3ch monitor
▶Displays current 3ch servo movement.
MENU22：Adjustment of 3ch position
▶Adjusting the movement amount of 3ch servo
in each position (position 01∼05)
Adjust using
1. Hold + key for a while
2. Use Forward/Back keys to choose positions
3. Push +/- keys to set positions.
Push both keys together to reset.
4. Push Forward key from (05 position) then
LCD displays "EXIT". Push + key to set.
5 positions (-100 / -50 / 0 / +50 / +100 ) are factory preset.
MENU23：Adjust volume
▶Recalibrate used volume settings
Adjust using 1. Hold + key for a while
2. Fully turn steering wheel to right/left
then release.
3. Fully pull/press throttle trigger in
forward/reverse position then release.
4. LCD displays"OK". Then, hold + key
for a while to set.
※CPU of the transmitter recognizes physical end points of
steering/throttle and neutral position. It corrects volume
consumption caused by frequently use or malfunction caused by shocks.
The use of this function will depend on your frequency of use and
your operation method
Caution!
This function can cause trouble when it is performed incorrectly.
We recommend sending this to our service department for repair,
when you are not familiar with this function.
3ch movement
­127 ∼ (Each default positions) ∼ ＋127
Calibration
Steering wheel
■MENU 21∼23
Foward key
+ key
− key
Back key
+ key
Throttle trigger
13