Ko Propo EX-5UR Instruction Manual page 11

MENU15：Throttle curve F
▶This function allows you to adjust throttle servo move-
ment on actual trigger operation (forward only).
Adjust using
＋/− keys. Push both keys together to reset.
※The throttle response can be made quick (＋) or mild (−)
＋ makes quick at start, and mild later
− makes mild at start, sensitive later
Quick curve (＋ values) reacts greatly at the start, and the
response becomes mild later
Mild curve (− values) reacts mild at the start, ant the response
becomes sensitive later
When using with other function, check the effect one by one.
MENU16：Throttle curve B
▶This function allows you to adjust throttle servo move-
ment on actual trigger operation (braking only).
Adjust using
＋/− keys. Push both keys together to reset.
※The throttle response can be made quick (＋) or mild (−)
＋ makes quick at start, and mild later
− makes mild at start, sensitive later
Quick curve (＋ values) reacts greatly at the start, and the
response becomes mild later
Mild curve (− values) reacts mild at the start, ant the response
becomes sensitive later
When using with other function, check the effect one by one.
MENU17：Throttle sub trim
▶This function allows you to adjust the edge of operation
and neutral position at the same time.
(Use when installing servo and test running)
Adjust using
＋/− keys. Push both keys together to reset.
※The whole operation angle including neutral position moves.
Use this function if you can not corrects neutral position by
adjusting servo horn or linkage.
Adjust "MENU11: Throttle trim" to adjust neutral position only.
When value of the sub trim gets bigger, adjust the linkage and
make it a smaller the value. In certain circumstances, too big
value may cause dead area (servo does not react) at the edge
of operation.
­50 ∼ 0 （Default setting） ∼ ＋50
­50 ∼ 0 （Default setting） ∼ ＋50
b30 ∼ 0 （Default setting） ∼ F30
■MENU 15∼17
+ key
− key
+ key
− key
+ key
− key
11