Table of Contents
Advertisement
DMX level 41-59 No change to relay status
DMX level 60-80 Relay enabled (normally closed)
DMX level 81-100 No change to relay status
SET DMX RESPONSE
DMX Response sets a delay time before DMX Control Mode settings are acted on. Setting a response delay of a few
seconds would prevent unintended fixture relay state changes in the event of a short accidental change in DMX
level.
NOTE: from firmware revision 0.00.100, DEC holds last valid DMX level if DMX is interrupted.
Response Delay Values are:
No Delay (default), 1, 2, 5, 10, 15, 20, 30, 60 seconds.
Set Temp Units
Choose to display temperature values in Celsius or Fahrenheit (default Celsius)
Note that temperature settings must be entered in Celsius.
Set Temp Ranges
Set three temperature trigger points for Bottom, Top and Trip temperatures, in °C.
SET TEMP LOWER (minimum temperature to be maintained)
(default 0°C, permissible range 0-10°C).
SET TEMP UPPER (maximum desired temperature)
(default 40°C, permissible range 35-50°C).
SET TEMP TRIP (temperature at which load will be isolated – see note)
(default 60°C, permissible range 55-70°C).
SET DELTA T (target difference between outside and inside temperature – drives fan speed)
(default ON (constant 100% fan speed), permissible range 2-10°C).
Note: A thermal emergency is when enclosure ventilation fails with the lamp on, in which case the temperature will
rise very quickly. To avoid nuisance tripping we recommend setting a higher Trip temperature, 60°C or above.
Set Lamp On Point
The lamp current at which DEC detects the luminaire/luminaire lamp is running. Default is 1 Amp, which allows for
equipment fans and power supplies to run without changing the air in the enclosure. Lamp on point may be set in
0.2 Amp increments between 0.2 Amps and 2.0 Amps.
Reset Lamp Hours
Reset each time you change the lamp in the luminaire.
Make this a part of your maintenance instructions.
Tornado G4 User Manual
31
Advertisement
Table of Contents
