Wiring The Enclosure; Power Wiring; Safety Notice; Electrical Standards - Tempest Tornado Marine G4 User Manual

Wiring the Enclosure

Power Wiring

SAFETY NOTICE

All power wiring must be performed by a competent electrician, appropriately licensed in the jurisdiction where the installation takes
place. All electrical work must be done in full compliance with all electrical and safety norms applicable to the installation site. Isolate
all power feeds before opening the enclosure.
Tempest Lighting, Inc., its employees and agents will not be held responsible for damage or injury caused by disregarding this notice.

Electrical Standards

Important:
Enclosure model numbers including .US are for use in countries using US and Japanese style electrical systems:
200-208VAC 50/60Hz
Enclosure model numbers including .IN are for use in countries using European style electrical systems:
220-250VAC 50/60Hz
Note:
(1) All Tornado and Tornado Marine G4 exhaust fans are 120VAC, regardless of electrical standard. The control electronics
provide a variable ac supply to the exhaust fans up to 120V.
(2) Heaters are rated 200-250V, dependent on electrical standard.
(3) Electronics are autosensing for any voltage 90-265VAC, 50/60Hz
(4) Tornado enclosures may be supplied wired for 120V operation to special order.
Wiring Access – Globe-up Models
Locate the two Conduit entry holes on the underside of
the enclosure:
Conduit openings accept PG21 (International) and ¾" NPT
(North America) conduit fittings.
Use permanent or flexible, outdoor rated, conduit to
connect power and signal cables to your Tornado
enclosure.
ALWAYS RUN POWER AND SIGNAL CABLES IN SEPARATE
CONDUITS.
Tornado G4 User Manual
Conduit Entry: Conduit Entry:
SIGNAL
AC POWER
13