Set The Lacp Port Priority Settings - NETGEAR GS724TPv2 User Manual

NETGEAR 24-Port Gigabit Smart Managed Pro Switch with PoE+ and 2 SFP Ports Model GS724TPv2
The System Information page displays.
5. Select Switching > LAG > Advanced > LACP Configuration.
6. In the LACP System Priority field, specify the device's link aggregation priority relative to
the devices at the other ends of the links on which link aggregation is enabled.
A higher value indicates a lower priority. You can change the value of the parameter
globally by specifying a priority from 1 to 65535. The default is 32768.
7. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.

Set the LACP Port Priority Settings

The LACP port configuration page is used to configure the LACP priority value for the selected
port and the administrative LACP time-out value.

To configure LACP port priority settings:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Switch on page 9.
The login window opens.
4. Enter the switch's password in the Password field.
The default password is password.
The System Information page displays.
5. Select Switching > LAG > Advanced > LACP Port Configuration.
Change the Default IP Address of the
Configure Switching
99