Table of Contents
Advertisement
SmarTouch STS Touchpanels
Daylight-Savings Screen
Interface Screen
4 • • SmarTouch STS: Touchpanels
Test) and buttons for special settings (DayLight Savings, Power Up On Last Page,
and Interface). Diagnostic buttons should only be used under supervision of a
Crestron technical support representative during telephone support. These options
are numeric in nature and their interpretation is beyond the scope of this Operations
Guide. Details of the special settings buttons are discussed in the following
paragraphs. Touch the RETURN button, located at the bottom of the screen, to
display the Preferences and Settings Menu.
Daylight Savings
To obtain the Daylight-Savings Screen, shown to the left of this paragraph, touch the
DayLight Savings button from the Advanced Settings Screen. Two options are
available: Set Daylight Savings Time Northern Hemisphere and Set Daylight
Savings Time Southern Hemisphere. Each button can be toggled (ON/OFF states).
Activating one of these buttons causes the real time clock to automatically adjust on
the appropriate dates for daylight-saving time. An activated button is indicated by a
changing the button's background color to blue (black for ST-1550). After verifying
the setting, touch the RETURN button, located at the bottom of the screen, to
display the Advanced Settings Screen.
NOTE: If you wish to completely deactivate the daylight-saving time feature, verify
that both buttons are not activated (both assume a background color of gray).
Power Up On Last Page
The state of the Power Up On Last Page button determines which screen appears
after a power down timeout. The ON state is indicated by changing the button's
background color to blue (black for ST-1550). As a result, the last screen to be
displayed reappears and restores all feedback when the touchpanel is activated after a
power down timeout. If desired, touch the button to turn it OFF; the button's text
assumes the same shade as all the other buttons on the screen. The OFF state
signifies that the first page of the project appears when the touchpanel is activated
after a power down timeout.
Interface
The touchpanel communicates with a ST-CP (for SmarTouch STS) or Cresnet
master computer (for Cresnet System). The communication interface must be
correctly specified or communication does not occur. These communication
parameters must match those assigned in the software project. To set communication
parameters select the Interface button from the Advanced Settings Screen and
display the Interface Screen, shown to the left of this paragraph. After
communication parameters have been verified, touch the RETURN button, located
at the bottom of the screen, to save the setting and display the Advanced Settings
Screen.
The CRESNET network identity number (NET ID) is displayed in the top left corner
of the Interface Screen. NET ID is only used during screen uploads to the touchpanel
and is identified by the two-digit hexadecimal number. "03" is shown as an example
in the illustration and happens to be the default. The down and up arrow buttons
decrease and increase the NET ID by one, respectively.
The radio frequency identity number (RF ID) is displayed in the top right corner of
the Interface Screen. This ID code is necessary to secure RF communications such
that controls can be activated from the touchpanel. The RF ID must match the
Crestron ST-1550 & ST-1550C
Operations Guide - DOC. 5803
Advertisement
Table of Contents
