Table of Contents
Advertisement
SmarTouch STS Touchpanels
Learn Sequence #1 Page
Schedule Event #2 Page
Sequences + Scheduler Page
6 • • SmarTouch STS: Touchpanels
1.
Touch the Start Sequence Learn button (reserved join number =
3072).
2.
Touch the programmable button. Its join number must be within the
reserved join number range from 3200 to 3327. In "st-1550/c basic
template.vtp", a number of programmable buttons with reserved join
numbers were grouped onto a single page, Learn Sequence #1, as
shown to the left of this step.
3.
Touch the Hit Here to Learn button at the bottom of the screen. The
opening menu of the project appears so that you can select buttons to
add to the sequence.
4.
Touch the buttons in the sequence at the same speed that you would
like to be replicated. These buttons can be from any page in the project.
5.
Each page in In "st-1550/c basic template.vtp" has a SEQ + SCHED
button. Use this button to return to the Sequences + Scheduler page
after touching all the buttons in the sequence.
6.
Touch the Finish/Cancel Learn button (reserve join number = 3073)
from the Sequences + Scheduler page.
Scheduling a Sequence/Button Press
The purpose of scheduling a sequence or button is to initiate an event at a
programmed date and time. The programmed date and time is defined as the
activation time. It is assumed that the sequence has been developed as described in
the previous paragraph or the preferred button initiates a function. A Schedule
Event button (found on the Sequences + Scheduler page in "st-1550/c basic
template.vtp") has a reserved join number (3424) and must be touched prior to
pressing the button to be scheduled. A "scratch" schedule laid out on the Schedule
Event #2 page, shown to the left of this paragraph, is made available so that the time,
date, and cycle of the event can be entered.
There are a number of fields on this page that can be set by selecting the Adjust
Time, Adjust Date, or Set Cycle buttons. Each of these buttons opens another page.
Once the "scratch" schedule information is assigned, it must be transferred to one of
thirty possible scheduled events. The Select Schedule button on the Schedule Event
#2 page opens the Schedule Event #3A page and permits the end-user to save the
schedule. Complete the following steps to schedule a sequence or button.
1.
Touch the Schedule Event button (reserve join number = 3424) from
the Sequences + Scheduler page, shown to the left of this step.
Crestron ST-1550 & ST-1550C
Operations Guide - DOC. 5803
Advertisement
Table of Contents
