Datavideo SE-2200 Instruction Manual page 9

Grounding Terminal
When connecting this unit to any other component,
make sure that it is properly grounded by connecting
this terminal to an
connecting, use the socket and be sure to use wire with
a cross-sectional area of at least 1.0 mm
DC Input
Connect the supplied 12V 3A PSU to this 4pin XLR
socket.
Pin 1 = GND ( - )
Pin 2 = NC
Pin 3 = NC
Pin 4 = VCC ( + )
Mini Switch 2
For firmware upgrades, switch both switches to the
upper position.
For Fast Start, please select lower position.
Service Port
This RJ45 Ethernet port is used to update the SE-2200
firmware, or upload logos and images using the
SEConfig software.
SDI Video Outputs
The six BNC output connectors are user defined SDI
outputs. Each of these SDI outputs has the option to be:
1. Program
2. Program logo free
3. Program logo & titles free
4. Preview
5. Aux1, 2, 3 or 4
6. Multi screen
Note: Please enter the SE-2200 MENU and select
OUTPUT SOURCE to set the output source.
9
appropriate point. When
2
.