Audio Function; Overview; Audio Follow Video - Datavideo SE-2200 Instruction Manual

AUDIO Function

Overview

The SE-2200 has a simple, cost effective, audio switcher built in. The SE-2200 has the ability to take
audio from several sources either XLR analogue, SDI and/or HDMI inputs. The audio can be
embedded onto the HDMI and SDI outputs and/or fed into the analogue XLR audio connections.
When using the audio functions of the SE-2200 switcher you may de-embed audio from selected SDI
or HDMI inputs and then output this audio from the XLR outputs of the switcher to a separate audio
mixer like the Datavideo AM-100 audio mixer.
Once the audio is mixed externally with any microphones or audio sources it can then be fed back
into the SE-2200 on the analogue XLR inputs. The SE-2200 can then embed this externally mixed
audio on to the Program SDI outputs.
Note: For a very basic audio set up , just loop the Audio outputs 1 & 2 to Audio inputs 1 & 2, using
the supplied CB-41 cable. For a more sophisticated audio processing set up, an audio mixer can be
added in the signal path as shown above. Due to its versatility many other system configurations are
possible as well.

AUDIO FOLLOW VIDEO

AUDIO FOLLOW VIDEO function, this means that the audio source will switch with the chosen
video input, and follow the T-bar function. The active audio is de-embedded and sent to the audio
output terminals for processing and/or audio levelling/ and or adding more audio sources. The
26