Ip Config - Planet Networking & Communication WAP-4036 User Manual

3.9

IP Config

The Wireless Access Point communicates with the wired/wireless clients through its LAN port. The
IP Config page allows you to define the IP address settings over the LAN interface.
Parameter
IP Address/Subnet
Mask/Gateway
Click "Apply" when you have finished the configuration above. And the wireless AP will be
automatically restarted if you change the LAN IP address.
If you change the private IP address and apply the changes, the PC from which you
configure the AP will lose the communication to the AP. To reconnect, you will need to
renew the IP address of the PC or change to an IP address compatible with the new LAN
port IP address.
Enter the IP address, Subnet mask and Gateway for the Wireless Access
Point LAN port. All local wired/wireless devices communicate with the device
through this port. It is also the IP address of the Web-based Configuration
Utility. By default, the IP address, Subnet mask and Gateway of the LAN port
is 192.168.1.1, 255.255.255.0 and 0.0.0.0 respectively.
Descriptions
24