CyberData 011049 Operation Manual page 3

Revision Information
Revision 930801M, which corresponds to firmware version 11.7.6, was released on March 9, 2017,
and has the following changes:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Operations Guide
Updates Figure 2-1, "Connections and Alternate Power
Updates Figure 2-3, "Devices Less than 1A at 30
Updates Figure 2-4, "Network Dual Door Strike Relay Wiring Diagram with External Power
Source"
Updates Figure 2-5, "Network Dual Door Strike Relay Wiring Diagram Using
Updates Figure 2-6, "Door Strike Relay Module Wiring Diagram from
Updates Figure 2-12, "RTFM
Updates Figure 2-13, "RTFM
Updates Figure 2-14, "RTFM
Adds Section 2.3, "Connecting an Auxiliary RGB Strobe to the Device"
Adds Section 2.4, "Connecting a SIP RGB Strobe to the Device"
Updates Figure 2-19, "Home
Updates Figure 2-20, "Device Configuration
Updates Figure 2-23, "SIP Configuration
Updates Figure 2-24, "SIP Configuration Page Set to Point-to-Point
Updates Figure 2-25, "Sensor Configuration
Updates Figure 2-31, "DSR Page (not associated with any
Updates Figure 2-32, "Autoprovisioning
Updates Figure 2-34, "Firmware
Updates Figure 2-35, "Home
Adds the following notes to
• Note: You must click on the Save button and then the Reboot button for the changes to take
effect.
• Note: The SIP Volume, Multicast Volume, Ring Volume, Sensor Volume, and Push to Talk
Volume settings do not require a reboot for the changes to take effect.
• Note: The NTP Server setting needs to be restarted to spawn NTP or to change the server.
Syncing and changing the Time update period (in hours) setting does not require a reboot
for the changes to take effect.
• Note: None of the Relay Settings require a reboot for the changes to take effect.
• Note: The Disable HTTPS (NOT recommended) setting requires a reboot for the changes to
take effect.
Adds the following notes to
• Note: You must click on the Save button and then the Reboot button for the changes to take
effect.
• Note: The Terminate Call After Delay setting does not require a reboot for the changes to
take effect.
Adds the following notes to
• Note: You must click on the Save button for the changes to take effect.
VDC"
Button"
Button"
Button"
Page"
Page"
Page"
Page"
Page"
Page"
Page"
Table 2-7, "Device Configuration
Table 2-13, "SIP Configuration
Table 2-16, "Sensor Configuration
930801M
Input"
PoE+"
Device"
Mode"
DSRs)"
Parameters":
Parameters":
Parameters":
CyberData Corporation