Table of Contents
Advertisement
2. Remove the 2 Qhillips screws in the access cover directly behind the power and data connectors. dift off
the cover.
3. docate the selection switches.
4. =ove the voltage switch to the setting that most closely matches the local !C voltage. If your voltage
falls halfway between 2 settings, select the higher voltage. Por example, if the !C voltage is 220 a, use
the 230 a setting instead of 210 a.
5. =ove the freYuency switch to the setting that matches the local !C freYuency: 50 or 60 eL.
6. Replace the cover.
I N S T A L L I N G A P L U G O N T H E P O W E R C A B L E
The power cable must be fitted with a groundingKtype cord cap that fits your power distribution system.
Consult an electrician if you have any doubts about proper installation.
• Following the cord cap manufacturer's instructions, connect the yellow and green wire to ground (earth), the
brown wire to live, and the blue wire to neutral. The table below shows some pin identification schemes.
A P P L Y I N G P O W E R
Warning!
The power cables must be undamaged and rated for the electrical requirements of all
connected devices.
Important! Powering through a dimmer system can damage the fixture.
1. aerify that the supply cable is undamaged and rated for the current reYuirements of all connected
devices.
2. Qlug the prepared power cable into the !C soc7et and a grounded !C power supply.
Installation
L O C A T I O N A N D O R I E N T A T I O N
The =!C 250 Arypton/4ntour may be installed in any orientation. It can be fastened directly to a suitable
surface, hung with a rigging clamp, or placed directly on a level surface.
Por safe operation, install the =!C 250 Arypton/4ntour in a location where:
D the fixture is at least 1 meters (39 inches) away from combustible materials
D the fixture is protected from rain and moisture
D there is at least 0.1 meters (4 inches) clearance around the fan and control panel
D there are no flammable materials nearby
R I G G I N G O R M O U N T I N G T H E M A C 2 5 0 K R Y P T O N / E N T O U R
Warning!
Block access below the work area before proceeding.
The =!C 250 Arypton/4ntour can be placed on stage or clamped to a truss in any orientation. The
PastKdoc7 system enables Yuic7 and easy fastening of the clamp brac7ets in 4 positions.
Wire
0in
brown
live
blue
neutral
yellow/green
ground
Table 1: Plug wiring
Mar2ing
Screw color
"L"
yellow or brass
"N"
silver
green
Advertisement
Table of Contents
