Table of Contents
Advertisement
F I R M W A R E V E R S I O N
→
startup.
Test and service utilities
D M X R E A D O U T
The D=c log (
displays the D=c refresh rate in pac7ets per second. aalues lower than 10 or higher than 44 may
result in erratic performance, especially when using trac7ing control.
displays the Yuality of the received D=c data as a percentage of pac7ets received. aalues much
below 100 indicate interference, poor connections, or other problems with the serial data lin7 that are the
most common cause of control problems.
displays the D=c start code. Qac7ets with a start code other than 0 may cause irregular
performance.
The remaining options under
(shutter, channel 1) to
reading the D=c values can help you troubleshoot the problem.
M A N U A L C O N T R O L
The manual control menu (
(
), and resetting the fixture (
E F F E C T S T E S T
The test seYuence (
Note: the test seYuence does not automatically stri7e the lamp. ]se
control lamp power. Qress lmenum to stop the test.
F E E D B A C K T O G G L E
=agnetic sensors monitor the positions of the color wheel, gobo wheel, and rotating gobos. If they detect an
error, the shutter closes while the effect resets. This feature can be disabled by turning effects feedbac7 off
→
(
A D J U S T M E N T P O S I T I O N S
The adWustment menu (
adWustment.
E F F E C T C A L I B R A T I O N
_ith the calibration menu (
value to compensate for small misalignments or differences between fixtures.
The default offset command (
C I R C U I T B O A R D T E S T
→
U P L O A D M O D E
The upload mode command (
not necessary, however, as upload mode is engaged automatically by the uploader.
displays the firmware version number. The firmware version is also displayed briefly at
) menu provides useful information for troubleshooting control problems.
display the D=c values received on each of the 13 channels, from
(effect speed, channel 13). If the fixture does not behave as expected,
) provides commands for turning the lamp on (
→
) runs through all effects to provide a Yuic7 chec7 of fixture performance.
→
).
→
→
→
executes a routine designed for testing the main circuit board. Por service use only.
→
). It also permits you to position and move individual effects.
) provides commands for positioning effects during mechanical
), effect positions can be fineKtuned with a softwareKdefined offset
) erases any offsets stored in memory.
) prepares the fixture for a software update. This command is
), turning the lamp off
→
→
and
to
Advertisement
Table of Contents
