Table of Contents
Advertisement
D
, the shortcuts setting which can be found under the Q4RS (personality) menu, determines whether
the color and gobo wheels scroll past open when changing positions. _hen set to
ita7e a shortcutk and scroll through open when this is the shortest path to the next position. The wheels do
not scroll past open when
D I S P L A Y
The display menu (
the display remain lit, or 1PP to extinguish the display two minutes after the last 7ey press.
To flip the display for easier reading, press lupm and ldownm simultaneously.
The display intensity setting (
automatic dimming of the display using the builtKin light sensor, or manually select an intensity level from 10
to 100.
L A M P P O W E R
There are two settings that modify lamp control: !utomatic damp 1n (
→
(
There are three options for automatic lamp control:
remains off until a lampKon command is received from the controller. _hen
automatically after the fixture is powered on. _hen
when the fixture receives D=c data, and it extinguishes automatically 15 minutes after D=c data is lost.
_hen !d1N is either 1N or D=c, lamp stri7e timing is determined by the fixture address to prevent all
lamps from stri7ing at once.
The D=c dampK1ff setting effects how the lamp can be turned off. _hen
switched off by sending a D=c value from 248 to 255 on channel 1 for five seconds. _hen
the lampKoff command will not wor7 unless special conditions are met. Refer to the D=c protocol.
R E S E T
The fixture can be reset from the controller if D=c reset (
, this command will not wor7 unless special conditions are met. Refer to the D=c protocol.
D E F A U L T S E T T I N G S
The fixture can be reset to its factory default settings by selecting
Information readouts
P O W E R - O N H O U R S
Read the total number of hours the fixture has been on since fabrication (
and the number of hours on since the counter was last reset (
used to trac7 maintenance intervals. Qress lupm for 5 seconds while displayed to reset.
L A M P H O U R S
Read the total number of lamp hours since fabrication (
of lamp hours since the counter was last reset (
installing a new lamp. Qress lupm for 5 seconds while displayed to reset.
L A M P S T R I K E S
Read the total number of lamp stri7es (
since the counter was last reset (
new lamp. Qress lupm for 5 seconds while displayed to reset.
is set to 1PP.
→
) determines whether the display remains lit or not. Select
→
).
→
) controls display brightness. You can select
,
, and
is set to
→
→
→
→
→
→
→
→
→
→
). Reset this counter when installing a
, the wheels can
→
) and D=c dampK1ff
. _hen
is
is
, the lamp stri7es
, the lamp stri7es automatically
is
, lamp power can be
) is set to
. If D=c reset is
→
→
→
→
→
→
). This can be
→
→
), and the number
→
). Reset this counter after
), and the number of lamps stri7es
to have
for
, the lamp
is
,
→
),
Advertisement
Table of Contents
