Table of Contents
Advertisement
5. ]sing a Qhilips screwdriver, remove the halfKcircle shaped plate that holds the prism into place (as
indicated in this illustration).
6. Remove the rubber belt to free the prism and replace it with a compatible rotating prism (contact your
=artin dealer for a list of available prisms).
7. Replace the rubber drive belt over the rotating prism and screw the halfKcircle shaped plate into place.
The prism should be able to rotate freely.
8. Reinsert the prism module into the fixture, reattach the leads (these are numbered) to the QCbs, and
screw the retaining plates into place.
9. Replace the top cover using a flathead screwdriver to tighten the four YuarterKturn screws.
10. Connect the fixture to !C power.
Mounting the optional 14° lens (MAC 250 Entour only)
The =!C 250 4ntour is supplied with an optional 14O lens. =ounting optional 14 degree lens. to mount the
lens:
1. Disconnect the fixture from !C power and allow it to cool.
2. doc7 the head in top side up position. Remove the top cover of the fixture head using a flathead
screwdriver to loosen the four YuarterKturn screws. The top and bottom cover loo7 the same, but the top
Advertisement
Table of Contents
