Ironman Fitness 6571 Owner's Manual page 14

A
Step 4.
1. Slide the Heel Holder Brackets (10) and Rubber Heel Holders (12) onto both ends of the
Front Leg Holder (6) until the teeth of Holder Bracket (10) are wedged into the slots on
Front Leg Holder (6), as shown in Figure A and B.
2. Insert Adjustable Boom (8) into the Front Leg Holder (6), making sure to guide Spring (14)
through to the rear of the Adjustment Boom (8).
3. At the rear of Adjustment Boom (8) secure the loop of Spring (14) as in Figure C with a
Hex Bolt (27), two Washer (40), and a Lock Nut (37). Tighten the Bolt (27) and the Lock
Nut (37) with the two Hex Wrenches provided.
4. By hand, screw Spring Knob (17) into Front Leg Holder (6).
5. Insert Square End Cap (21) into the rear of Adjustable Boom (8).
NOTE: Make sure the lock teeth are wedged into the slots of the Front Leg Holder (6) and
Adjustable Boom (8) to lock the Heel Holder Brackets (10) and Rubber Heel Holders (12) firmly in
place around your ankles before use.
NO. 27 Hex Bolt
M6x47
1PC
ASSEMBLY
B
NO. 37 Lock Nut
M6 1PC
NO. 40 Washer
Ø12xØ6.5x1.0
12
Hex Wrench 2 PC
C
2PCS